Appliance description
(See fold-out page for illustrations)
1 Hanger
2 Locking stud for the hanger
3 Locking clip for locking the telescopic rod
4 Telescopic shaft
5 Drip protection
6 Blower
7 Release button
8 LED display
9 Dial
0 Appliance base
q Weight clamps to weigh down the clothes
w Cable retainer
e Nylon balloon to put the clothes on
Operating the appliance
CAUTION! PROPERTY DAMAGE!
►
When setting up the appliance, ensure that it has sufficient free space on all
sides .
Assemble the appliance before use . Use the illustrations on the fold-out page for
additional help .
♦
Push the telescopic shaft 4 into the opening provided at the top of the
appliance base 0 until it clicks into place . The drip protection 5 must be
located above the blower 6 . Make sure that it is installed at a height of at
least 10 cm above the blower 6 .
NOTE
►
To remove the telescopic shaft 4 again if necessary, press the release
button
♦
Adjust the height of the telescopic shaft 4 . Open the locking clip 3, pull out
the telescopic shaft 4 to the desired height and tighten the locking clip 3
again . Pull the telescopic shaft 4 far enough out so that the hanger 1 can
be attached .
■
8
│
GB │ IE │ NI
7 and pull out the telescopic shaft 4 .
SBP 1960 A1