Perel EDKM1 Bedienungsanleitung Seite 8

CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the
like.
Do not puncture batteries or throw them in fire as they
may explode. Do not attempt to recharge non-rechargeable
batteries (alkaline). Dispose of batteries in accordance with
local regulations. Keep batteries away from children.
5. Installation
Test the operating range between the receiver and the
transmitter. The operating range is 150 m in the open air,
but may be less due to walls and other obstructions such
as PVC or metal frames.
Refer to the illustrations on page 2 of this manual.
Transmitter
1. Carefully open the housing of the transmitter and use the back
plate as a template. Mark the drilling holes at the required
height.
2. Drill the holes using a drill and the appropriate drill bit (not
included).
3. Insert a nylon plug (included) into each hole.
4. Fix the back plate with the included screws. Click the front plate
onto the back plate.
5. Apply a name tag [1] if desired.
Remark: You can also fix the transmitter using double-sided tape.
Receiver EDKM1
1. Choose the installation spot for the receiver.
2. The receiver can be fixed to a wall using a hook or nail [6].
Receiver EDKP1
Plug the receiver into the mains.
V. 02 – 10/07/2017
EDKP1/EDKM1
8 ©Velleman nv