Machine Description; Recommended Use - BATTIPAV VIP 2125 Bedienungsanleitung

Battipav srl
Don't abuse cord
• Never carry tool by cord or yank it to disconnect it from socket. • Keep cord from heat, oil and sharp edges.
Avoid unsteady positions
• Be sure to work in a safe and balanced position.
Maintain tools with care
• Keep tools sharp and clean for better and safer performance.
• Follow all maintenance advice and instructions to replace accessories subject to wear. Inspect tool cords
periodically and, if damaged, have them repaired by an authorised expert. Check extension cords periodically
and replace them if damaged. Keep handles dry, clean and free from oil and grease.
Disconnect tools
• When not in use, before servicing, and when changing accessories subject to wear.
Remove service keys from tool
• Form the habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on.
Avoid unintentional starting
• Be sure that the switch is off when plugging in the tool.
Extension cords for outdoor works
• When tool is used outdoors, use only extension cords intended for this particular use and so marked.
Stay alert
• Watch what you are doing. Use common sense. Do not operate tool when you are inattentive.
Check tool for damaged parts
• Before further use of the tool, check it and the safety devices for damages and be sure that they operate
properly. Check for functioning and binding of moving parts, breakage of parts, correct mounting, and any
other conditions that may affect the correct operation of the tool.
• Damaged safety devices or other parts should be properly repaired or replaced by an authorised Service Centre
unless otherwise indicated elsewhere in this instruction manual.
• Have defective switches replaced by an authorised Service Centre.
• Do not use tool if its switch cannot be turned on or off.
Warning
• For your personal safety use only accessories recommended in this instruction manual or in the relevant
catalogues The use of any other accessory or attachment other than those recommended in this instruction
manual or in the relevant catalogue may present a risk of personal injury.
Have tools repaired by qualified personnel
• This electric appliance is in accordance with the safety rules in force. Only qualified experts may carry out
repairing of electric appliances otherwise it may cause considerable danger for the user.
*
1
The noise level emitted by the machine was measured in accordance with the UNI EN12418, EN3744
standards.
The machine in working conditions has a noise emission higher than 85 dB (A).
* 2
The vibration level transmitted to the hand-arm system was measured in accordance with the UNI EN ISO
5349-1.

MACHINE DESCRIPTION

The VIP site cutter is a machine intended specifically for cutting ceramics, single-fired items, terracotta, and
marble (Max thickness 20 mm), up to a thickness of 40 mm.
The machine uses a wet diamond tipped tool cutting system and is intended for personnel specialized in the
construction sector. The operator works in front of the narrow side of the machine, within reach of the operating
controls, and positions the material to be cut on the moving worktop. He/she starts the machine and moves the
cutting head to bring the tool into contact with the material.

RECOMMENDED USE

CUTTING TOOL: DIAMOND BLADE WET CUTTING
CONTINUOUS CROWN: ceramic, marble, stone, single-fired ceramic
LASER/SECTORS:
ceramic, single-fired ceramic, cotto and marble (max. thickness 20 mm.)
THE TOOL / MATERIAL TO BE CUT MATCHES ARE PURELY INDICATIVE.
ALWAYS FOLLOW THE INTENDED USE INDICATIONS PROVIDED BY THE CUTTING TOOL MANUFACTURER
GB
25