Usb Operation; Troubleshooting - Sharp HT-SB147 Handbuch

can use the soundbar's remote control
to play music stored on the device.
1. Pair your device with the player.
2. Play music via your device (if it
supports A2DP).
3. Use supplied remote control to control
play (if it supports AVRCP).
– To pause/resume play, press the
button on the remote control.
– To skip to a track, press the
buttons on the remote control.

USB Operation

1. Insert USB storage drive into the USB
slot on the rear panel.
2. Press
button repeatedly on the unit
or button on the remote control to
select USB mode.
3. Unit will start playing the MP3 track
automatically from the connected
USB drive.
If the MP3 playback does not start
automatically, press
remote control.
– To pause/resume play, press the
button on the remote control.
– To skip to a track, press the
buttons on the remote control.
– Press and hold
fast reverse.
– Due to the numerous diff erent fi le
systems and fi le formats, compatibility
with the connected memory media
cannot be guaranteed.
– Depending on the size of the data
medium, it may take some time for the
system to be detected.
– The supported fi le format is MP3/WAV.
– External hard disks are not supported.
– Supports USB memory key up to 32GB.

Troubleshooting

To keep the warranty valid, never try
to repair the system yourself. If you
encounter problems when using this unit,
review the following before requesting
service.
/
button on the
/
to fast forward,
No power
Ensure that the AC cord is properly
connected.
Ensure that there is power at the AC
outlet.
Press standby button on the remote
control or soundbar to turn the soundbar
on.
No sound
Increase the volume. Press Volume Up on
the remote control or on the right side of
the soundbar.
Press on the remote control to ensure
the soundbar is not muted.
Press source buttons to select a diff erent
input source.
When using either of the Digital input, if
there is no audio:
– Try setting the TV output to PCM or
– Connect directly to your Blu-ray/other
source, some TVs do not pass through
digital audio.
Your TV may be set to variable audio
output. Confi rm that the audio output
setting is set to FIXED or STANDARD, not
VARIABLE. Consult your TV's user manual
for more detailed information.
If using Bluetooth, ensure that the volume
on your source device is turned up and
to
that the device is not muted.
Remote control does not work
Before you press any playback control
button, fi rst select the correct source.
Reduce the distance between the remote
control and the unit.
Insert the battery with its polarities (+/-)
aligned as indicated.
Replace the battery.
Aim the remote control directly at the
sensor on the front of the unit.
I hear buzzing or humming
Ensure all cables and wires are securely
connected.
Connect a diff erent source device (TV,
Blu-ray player, etc) to see if the buzzing
persists. If it does not, the problem may
EN