Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
• WEATHERPROOF SEALED CASE
• DIGITAL CIRCUITRY
• D - TEC™ SENSING SYSTEM (DTSS)
• LOW BATTERY DRAIN
•MULTICOLOUR (X4) LED'S
'
1. Turn off
2. Using a cross head
unit prior to
screwdriver unscrew
fitting or
the two battery cover
replacing
screws.
batteries.
3. Pull the tab upwards
from the bottom of
the battery cover.
DO NOT over tighten the battery compartment screws,
excessive force will damage the screw threads.
4. Take care removing the bat-
teries. Insert new batteries and
ensure correct polarity.
5. For best weatherproofing,
ensure battery cover has a good
seal by firmly pushing lip into
the top edge of the case and
pivoting it into position.
6. Re-fit cover and screws.
• Push down the toggle switch and release to activate the unit.
• Push up and release the toggle switch in the top position to deactivate the unit.
Please ensure the unit is switched off before attempting to fit the Mini Micron X
hardcase.
• Do not use excessive force when fitting the hardcase as this may result in damage
to the alarm.
Volume can be cycled incrementally
by presseing the volume button and
then releasing.
Tone can be cycled incrementally
by pressing the tone button and
then releasing.
Sensitivity can be cycled
incrementally by pressing the
sensitivity button and then
releasing.
The LED colour can be changed by
holding down the volume button and
then pressing the sensitivity button.
Each time the sensitivity button is
pressed the LED colour will change.
The LED intensity can be toggled
between three different intensities.
Simply hold down the volume and
press the tone button.
Each time the tone button is
pressed the LED intensity will
change.
Power Out Socket allows Fox Illuminated Bite Indicators to be powered directly
from the Micron. The Illuminated Bite Indicator will then light up when the Micron is
activated and latch for approximately 20 seconds.
Werbung
