Troubleshooting; Reversing The Door Opening - Inventum NM010++ Gebrauchsanweisung

7

troubleshooting

Problem
Appliance is not functioning;
light does not work
Temperature inside the
freezer is too high or too low
Appliance is excessively noisy
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
8

reversing the door opening

It is possible to change the door opening from either the left or the right side. To change the opening direction, please follow these
instructions.
Note: Before reversing the door swing, turn the thermostat off [ � ] and unplug the appliance from the mains. Empty the
appliance, including the shelves before reversing the door opening.
• Remove the screws at the back, holding the top panel to the appliance.
• Lift the top panel and remove it.
• Remove the bolts from the left top side and remove from the right top side the hinge with the bolts (mind the plastic parts
between the hinge and the door).
• Remove the door by carefully lifting it from the bottom hinge. Put the door in a safe place.
• Remove and fit the plastic nog from the right side to the left side.
• Tilt the appliance 45°.
• Unscrew the bolts and remove the bottom hinge. Install the bottom hinge on the opposite side und replace the bolts in the
provided holes.
• Replace the front leg on the right side with the bolts.
• Place the door against the appliance and make sure it is well fitted on the bottom hinge.
• Refit the hinge on the left top side (mind the plastic parts) with the bolts. Make sure the door is alligned with the outside of the
appliance.
• Set the appliance carefully upright.
• Screw the bolts back on the right top side.
• Remove the plastic part from the inside of the top panel and place it on the opposite side.
• Refit the top panel using the screws.
• Leave the appliance to stand for at least 3 hours before you insert the plug into the socket.
18
• English
Cause
Appliance is not plugged in
Thermostat has been set incorrectly
Air circulation vents are blocked
Has the appliance been installed correctly?
Are the pipes at the back touching or vibrating?
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance
forwards