venton SV-170 Benutzeranleitung Seite 16

ASSEMBLE OF BLADE AND GRILLE
•
Unscrew the plastic mounting nut from the front of the motor
housing by rotating it anticlockwise.
•
Position the rear grille against the front of the motor housing with
the handle uppermost, ensuing that the locating pegs on the motor
housing are engaged correctly in the holes of the rear grille.
•
Tighten the Rear Grille Mounting Nut clockwise. DO NOT
OVERTIGHTEN IT.
•
Push the fan blade onto the motor shaft, locating the slot at the
back of the blade on the drive pin that passes through the motor
shaft.
•
Tighten the blade cap by turning it anticlockwise.
•
Position the front grille against the rear grille so that the holes in the
rims that accept the small nut and bolt are in line. Insert the bolt
through the holes and screw on the nut. Do not fully tighten at the
stage.
•
Push the grille retaining clips into position ensuring that they
engage correctly on the rim of the grille.
•
Fully tighten the small nut and bolt that passes through the rim of
the grille.
USE
Before each use check that the appliance is in good condition and that the
electric cable is not dam- aged; if the electric cable is damaged, it must be
replaced by the manufacturer or by the technical assistance service or, in
the event, by a qualified technician, in order to avoid any type of danger.
Insert the plug into the mains socket.
Set wind speed (Fig 2)
Adjust the fan speed by rotating the speed switch on the motor cover.
0.OFF
1.Low Speed
2.Medium Speed
3.High Speed
16