Herunterladen Inhalt Inhalt Diese Seite drucken

venton SV-170 Benutzeranleitung Seite 15

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

advisable; if this is necessary, they must be in accordance with the
safety regulations and their amperage capacity must not be less
than the maximum for the appliance.
Before each usage, check that the appliance is in good condition
and that the power cord is not damaged: if in doubt, check with a
professional, qualified technician.
The mains socket must be easily accessible in order to disconnect
the appliance with ease in case of emergency.
Position the appliance away from:
- sources of heat (e.g. open flames, gas ovens, etc.)
- deposits of liquids (e.g. sinks, etc.) to avoid falling into or
splashing with water (minimum distance 2 metres).
- fabrics (curtains, etc.) or loose materials, which may obstruct the
ventilation grille; in addition, check that the front part is free of
volatile materials (dust, etc.).
The supporting surface must be stable, flat and even (so that the
appliance does not tip over).
ASSEMBLY
Warning: the fan may be used only if it is fully and properly assembled, that
is to say, complete with the base and the grille.
Warning: always disconnect the appliance from the mains supply before
assembling. if in doubt, have the operation checked or carried out by a
qualified technician. For the assembly refer to Fig. 1.
ASSEMBLE OF BASE
Set the column in place on the base and secure it using the "L"
screw with washer while also engaging the counterweight.
Make sure column and base and counterweight are firmly coupled.
Insert the upperpart tube into underpart, tighten with the height
adjustment knob,
Insert the neck and the motor part into the upper part column and
tighten with the height adjustment nut,
If necessary, you can only set the underpart column use as the floor
fan. Make sure the Set Screw is tightly secured.
15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis