Operation - Panasonic EY47A1 Bedienungsanleitung

Attaching or removing
Battery Pack
1. To connect the battery pack: [Fig. 6
]
Line up the alignment marks and
attach the battery pack.
• Slide the battery pack until it locks
into position.
2. To remove the battery pack: [Fig. 6
]
Pull the button from the front to
release the battery pack.
Adjusting handle angle
The handle position can be set to 4
different angles.
• Slide the handle lock release lever to
set the handle angle. [Fig. 7] [Fig. 8]
• Before working, be sure to move the
handle up and down to make sure the
angle is fixed.
Adjusting the position of
the protect shoe
You can adjust the shoe position by
inserting a hexagon wrench at the
bottom of the main unit as shown in the
figure and loosening the internal shoe
adjustment screw about one turn. [Fig.
9]
• If the blade sharpness becomes poor
due to the use of the same part of the
blade, the unused part can be used by
adjusting the position of the shoe, and
the life of the reciprocating saw blade
can be extended.
• After adjustment, be sure to tighten the
adjustment screw.
• The shoe cannot be removed.
• Do not loosen the shoe adjusting
screw more than 2 turns as it may
cause a malfunction.
CAUTION
• While working, press the protect
shoe firmly against the material to
be cut.
• Do not apply excessive force when
cutting.
• When cutting into a small arc,
reduce the feed rate.
VI. OPERATION
1. While pushing down the switch lock
release lever, pull the power switch.
[Fig. 10]
• The switch lock can be disengaged
by pushing in the switch lock
release lever from either side.
• The speed increases with the
amount of depression of the power
switch.
• While you are on the power switch,
the tool will continue to operate
even if you remove your fingers
from the switch lock release lever.
2. Once cutting is finished, release the
power switch.
3. Check that the temperature of the
blade has dropped sufficiently, and
then remove the blade.
When operating the tool by pulling
the trigger, there may be a
momentary lag before rotation starts.
This does not signal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled
for the first time after installing a new
battery pack or after the tool has not
been used for at least 1 minute.
Rotation will start without any lag
during second and subsequent
operations.
Cutting
NOTE:
• Hold the protective shoe against the
material being cut, taking care to align
the reciprocating saw blade with the
desired cut position, and pull the
switch.
• The blade may vibrate occasionally,
which is a normal phenomenon.
• If cuttings accumulate on the uneven
surfaces near where the reciprocating
saw blade is attached, clean them off
before resuming work.
• Check that there are no obstacles to
cut underneath workpiece.
– 15 –
EN