Mounting The Handle For Sht300Xf Und Sht350Xxf; Fastening The Foot Lever (For Sht150Xf, Sht300Xf And Sht350Xxf); Operation; Before Each Use - HOLZMANN-MASCHINEN SHT150XF Betriebsanleitung

16.1.3 Mounting the Handle for SHT300XF und SHT350XXF

16.1.4 Fastening the Foot Lever (for SHT150XF, SHT300XF and SHT350XXF)

17

OPERATION

17.1

Before Each Use!

Do not use lifting table if you notice a malfunction or damage!
Check the following points daily or before each use of the machine:
 Check the machine for damage.
 Check the hydraulics for leaks.
 Check the brakes and castors for function.
 Make sure all screws and bolts are tightened.
Do not use the machine, if you notice any malfunction or damage!
17.2

Operating the Machine

17.2.1 Locking the Brake

Locking brakes (8) are located at the side of the steering castors.
 Press brake pedals to lock the castors.
 Lift brake pedals to release the castors.

17.2.2 Loading the Table

The machine is designed for a maximum permissible load (loading capacity). Take care not to
overload the table. Do not concentrate the load on one side of the table. The load must be
distributed over at least 80 percent of the table surface.
HOLZMANN MASCHINEN GmbH
1. Anchor handle (B1) in the fixing holes of the vehicle frame by
using screws (B7), spring washers (B6) and washers (B5).
2. Tighten screws (B7) firmly with a wrench.
1. Insert foot lever (B31) into the hole.
2. Place washer (B27), spring washer (B28) and screw (B29).
3. Tighten the screw (B29) with a wrench.
CAUTION
www.holzmann-maschinen.at
OPERATION
SHT150XF | SHT300XF | SHT350XXF
22