Installation - Leonard LAS6100F Benutzerinformation

You cannot activate or operate
the appliance.
The residual heat indicator
does not come on.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.

INSTALLATION

Warning! Refer to the Safety chapters.
Before the installation, note down
the serial number (Ser. Nr.) from the
rating plate.The rating plate of the
appliance is on its lower casing.
LAS6100F
220-240 V 50-60 Hz
58 PEE 11 AO
Made in Germany
Leonard
Built-in appliances
• Only use the built-in appliances after you
assemble the appliance into correct built-
Assembly
min.
500mm
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
Problem with the house electri-
cal system.
The cooking zone is not hot
because it operated only for a
short time.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
in units and work surfaces that align to
the standards.
Connection cable
• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C;
949 594 292 00
or higher). Speak to your local Service
6 kW
Centre.
min.
50mm
55mm
Check if the appliance is cor-
rectly connected to the electri-
cal supply (refer to connection
diagram).
Examine the fuse in the electri-
cal system of the house in the
fuse box. If the fuses blow
again and again, speak to
qualified electrician.
If the cooking zone operated
sufficiently long to be hot,
speak to the service centre.
R 5mm
+1
+1
490 mm 560
mm
leonard 15