KidKraft FORESTVIEW II Installations-Und Betriebsanleitungen Seite 4

Tools Required
• Carpenters Level
• Carpenters Square
Part Identification Key
On each page, you will find the parts
and quantities required to complete the
assembly step illustrated on that page.
Here is a sample.
Symbols
Throughout these instructions symbols are provided as important reminders for proper and safe assembly.
This identifies information that requires special
attention. Improper assembly could lead to an
unsafe or dangerous condition.
Use Use
Help Help
Measure
Distance
Check that assembly is square
before tightening bolts.
Use a measuring tape to assure
proper location.
CAUTION – Protrusion Hazard
Once the assembly is tightened, watch for exposed
threads. If a thread protrudes from the T-Nut, remove
the bolt and add washers to eliminate this condition.
Extra washers have been provided for this purpose.
Proper Hardware Assembly
Lag screws require drilling pilot holes to
avoid splitting wood. Only a flat washer
is required. For ease of installation
liquid soap can be used
on all lag-type screws.
For bolts, tap T-Nut into hole with
hammer. Insert the hex bolt through
lock washer first then flat washer then
hole. Because the assemblies need to
be squared do not completely tighten
until instructed. Pay close attention to
diameter of the bolts. 5/16" is slightly
larger than 1/4".
Note: Wafer head bolts with blue lock
tight or a bolt with a Ny-Lok nut do
NOT require a lock washer.
Keys to Assembly Success
• C a l w H a m m r e
• T a e p M a e u s e r
1
2 X
Quantity
Where this is shown, 2 or 3
people are required to safely
complete the step. To avoid
injury or damage to the
assembly make sure to get
help!
Square
Assembly
Lag Screw
• Standard or Cordless Drill
• Pencil
Key Number
Check that set or assembly is properly level
before proceeding.
Pre-drill 1/8" & 3/16" Bit
This indicates time to tighten bolts, but
not too tight! Do not crush the wood.
This may create splinters and cause
structural damage.
No
Lag Assembly
Flat Washer
Bolt Assembly
Hex Bolt
Lock
Washer
Flat
Washer
3
• Safety Glasses
• Adult Helpers
Pre-drill a pilot hole
before fastening screw
or lag to prevent
splitting of wood.
Tighten
Bolts
Yes
If Bolt protrudes
beyond T-Nut
Use an extra
flat washer
Before mounting Lag
Screw, use factory drilled
holes as guides to drill 1/8"
pilot holes
T-Nut
(Hammer into place)
Do not crush wood!
Use
Level