Variable Inner Door; Defrosting - Electrolux EK 6 7000 Bedienungsanleitung

zen and the process control is carried out
automatically.
Products for freezing should not be bro-
ught into contact with products which
are already frozen. Products which have
been thawed out must not be re-frozen
because foodstuffs can spoil.
Variable inner doors
The cover inserts in the inner doors can be
adjusted somewhat and offer the option of
a customized setting. To change the loca-
tion of the inserts and bottle holder: first
quence. (fig. ;).
lift upwards and lift out, then set the requi-
red height and replace in the reverse se-

Defrosting

The refrigerator defrosts automatically. Ice
which has formed on the back wall is mel-
nel (fig. =) and evaporates from the collec-
ted (about once per day, see also the tips).
The water flows out of the drainage chan-
tion dish outside the refrigerator.
Be sure to keep the collection channel and
the drainage channel clean, so that the
melted water can flow out easily. Clean
out the drainage channel with the green
cleaner provided using an up-and-down
and turning motion.
Defrost the freezer compartment if the ice
formation becomes excessive. A thick coa-
ting of ice reduces the effectiveness of the
cold transfer to the frozen products. Keep
the frozen products as cold as possible and
well insulated during the defrosting time,
e.g. pack them in newspaper.
– Set the temperature controller to
position «0».
– Leave the doors open.
;
=
Defrosting can be accelerated significantly
if you place a bowl of hot water in the fre-
ezer compartment. Attention: do not use
sharp implements to remove ice or any-
thing hard frozen. Do not use an electrical
heater or an open flame for defrosting.
– After defrosting clean the interior and
dry it thoroughly.
– Move the temperature back to Position
Normal between the two temperature
symbols. Replace the frozen products.
35