ECOVACS DEEBOT OZMO T9 DLX13 Bedienungsanleitung Seite 20

No. Malfunction
DEEBOT misses cleaning spots to
7 be cleaned, or repeats cleaning the
area cleaned.
DEEBOT is not able to connect to
8
the home Wi-Fi network.
DEEBOT does not clean the
9
whole area.
DEEBOT Side Brushes drop out of
10
place during use.
EN
20
Possible Causes
The cleaning cycle is interfered by small objects or
barriers on the floor.
DEEBOT is working on slippery polished floors.
DEEBOT is unable to reach certain areas blocked
by furniture or barriers.
The TrueMapping Distance Sensor is blocked.
Incorrect home Wi-Fi username or password
entered.
Incorrect App installed.
DEEBOT is not within range of your home Wi-Fi
signal.
Network setup started before DEEBOT was ready.
DEEBOT does not support 5 GHz Wi-Fi.
The cleaning area is not tidy.
The Side Brushes are not correctly installed.
Solutions
Remove power cords and small objects from the floor to ensure
cleaning efficiency. DEEBOT will automatically clean the area
missed, please avoid moving DEEBOT manually or block the
path during the cleaning cycle.
Make sure the floor wax is dried before DEEBOT starts cleaning.
Tidy up the area to be cleaned by putting furniture and small
objects in their proper place.
Remove the objects that are blocking the TrueMapping Distance
Sensor.
Enter the correct home Wi-Fi username and password.
Please download and install ECOVACS HOME App.
Make sure DEEBOT is within range of your home Wi-Fi signal.
Turn ON Power Switch. Press the RESET Button. DEEBOT is
ready for network setup when its Wi-Fi Indicator light flashes
slowly.
Make sure the robot has been connected with 2.4 GHz Wi-Fi
network.
Remove small objects from the floor and tidy up the cleaning
area before DEEBOT starts cleaning.
Make sure the Side Brushes click into place when installing.