Rear Panel; Remote Control Unit - Denon Professional DN-A300M Bedienungsanleitung

ENGLISH
Getting Started
• When the VOLUME control knob is set just
beyond the "12 o'clock" position (over halfway),
the adjustments that can be made with the
BASS and TREBLE controls is decreased.
• When the VOLUME control knob is set to
maximum or turned fully clockwise, the bass and
treble can no longer be adjusted.

Rear panel

SIGNAL GND (ground) terminal
Connect the ground wire from your turntable
here.
NOTE:
• This terminal is not a safety ground.
INPUTS terminals
Connect your source equipment here.
Recording input/output terminals
(TAPE-1 and TAPE-2)
Connect your recording equipment here.
PRE OUT terminals
Use this to add such equipment as a power
amplifier or subwoofer.
(21)
MIC SENSE LEVEL knob
The mic input sensitivity can be adjusted.
Left turn is low sensitivity.
Right turn is high sensitivity.
(22)
MUSIC MUTE LEVEL knob
The source input attenuation level can be
adjusted(-20dB ~ 0dB) when mixing mic input
with source input.
NOTE:
❽ (21) (22)
• Functions , , and are only available
when the MIC MIX function is turned on.
(23)
SPEAKER SYSTEMS terminals
Connect your speakers here.
(24)
AC OUTLETS
Use these as the power outlets for other audio
devices. Check equipment power requirement
ratings before use(see the ratings as marked on
the rear panel). If in doubt consult with your
dealer or DENON PROFESSIONAL distributor.
• Short-circuiting plugs are inserted into the
PHONO input terminals. Remove these when
connecting a turntable. Be sure to keep it for
future use.
NOTE:
• NEVER insert the short-circuiting pin plug into
the recording output or PRE OUT terminals.
Doing so could result in damage.

Remote control unit

Amplifier operating
buttons
SPEAKERS A/B button
This switches the speakers
connected to speaker terminals.
POWER button
This operates the main unit's
power.
Input selector buttons
These switch the input source.
MUTE button
Press this to mute the sound.
The power indicator on the main
unit blinks red.
Press again to produce sound.
LOUDNESS button
This amplifier the bass and treble
sound that is hard to hear at low
volume level and achieves a
more natural sound.
Volume +, - buttons
These adjust the volume.
MIC MIX button
This mixes mic input with source
input and outputs them.
MIC AGC button
This adjusts the level to prevent
clipping the sound.
AUTO MUSIC MUTE
button
This outputs source input as its
level is attenuated with the
MUSIC MUTE LEVEL knob on
the rear panel.
• The included remote control unit can be used to operate DENON PROFESSIONAL CD players, tape
decks and tuners.
• When using it, also refer to the operating instructions of the other devices.
• Some products may not be operable.
3
ENGLISH
Getting Started
DENON
PROFESSIONAL
product operating
buttons
TUNER block
TUNER PRESET +, -
These switch the preset
channel.
CD player block
0~9, +10 :
Number buttons
DISC SKIP :
This button selects the disc, when
using a DENON PROFESSIONAL
multi-disc CD player.
: Play
:
Pause
:
Stop
:
, Search
RANDOM :
Random playback
REPEAT :
Repeat playback
Tape deck block
:
Rewind
:
Fast-forward
: Reverse play
:
Forward play
A/B :
Switch between decks
A and B for double
decks
REC :
Record
:
Pause
: Stop