Operation; Preparations Prior To Playing; Starting Playback; Input Selector - Denon Professional DN-A300M Bedienungsanleitung

Operation

MIX
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit

Preparations prior to playing

1
Set the volume to the minimum by using
2
< BASS > < TREBLE >
Set , and
to the center position.
3 < POWER >.
Turn on the power by pressing
• The power indicator blinks red for several seconds, then lights
green.
Turning the Power Off
① Press [POWER]
• The power indicator lights red and the power is set to the standby
mode.
• When in the standby mode, press [POWER] to turn the power on.
② Press <POWER>
• The power indicator turns off, and so does the power.
NOTE:
• Power continues to be supplied to some of the circuitry even
when the power is in the standby mode. When leaving home for
long periods of time or when traveling, either press <POWER> to
turn off the power, or unplug the power cord from the power
outlet.

Starting playback

1

INPUT SELECTOR

Use to select the source to
be played.
• Select one of the sources among the following: TAPE-2, TAPE-
1, PHONO, CD, TUNER and DVD/AUX.
• The input indicator for the selected source lights.
2
Play the selected source.
3
VOLUME.
Adjust the volume by using
4 < BASS >
Adjust the tone with
< BALANCE > LOUDNESS .
and
6
ENGLISH

Using the microphone

1
VOLUME Plug the microphone with 1/4" jack.
.
2
MIC MIX
< BALANCE > Set
• The MIC MIX indicator lights orange, then the mic input can be
mixed with the source input.
3
AUTO MUSIC MUTE
Set
ON OFF
" " or "
• AUTO MUSIC MUTE can be setting the mute level.(Page 3)
4
Adjust the mic level by using
5 Use the microphone.
NOTES:
• When not using the microphone, unplug it.
• DN-A300M does not have Phantom Power.
• It is recommended to use a microphone equipped with a talk
switch. Otherwise, the music source may be muted if a trigger
signal is output. Please turn AUTO MUSIC MUTE button off
when you do not use a microphone.

Starting recording

1
INPUT SELECTOR
Use
(other than TAPE-1 or TAPE-2) to be recorded.
• When you select PHONO, CD, TUNER or DVD/AUX, recording
can be made on TAPE-1, TAPE-2 or both simultaneously.
2
Set the device connected to the TAPE-1 (or TAPE-2)
terminal to the recorded mode.
< TREBLE >
3
, , Start playing the source to be recorded.
ENGLISH
ON
to " ".
MIC AGC
and to
".
<MIC LEVEL>
.
to select the source