Inserting The Batteries; Operating Range Of The Remote Control Unit; Part Names And Functions; Front Panel - Denon Professional DN-A300M Bedienungsanleitung

Getting Started

Inserting the batteries

①
Remove the remote control unit's rear cover.
②
Set two R03/AAA batteries in the battery
compartment in the indicated direction.
③
Put the rear cover back on.
Notes on batteries:
• Replace the batteries with new ones if the set
does not operate even when the remote
control unit is operated nearby the unit. (The
attached batteries are only for verifying
operation.)
• When inserting the batteries, be sure to do so
in the proper direction, following the "⊕" and
"⊖" marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an
old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or
dispose of batteries in flames.
• If the battery fluid should leak, carefully wipe
the fluid off the inside of the battery
compartment and insert new batteries.
• Remove the batteries from the remote if it will
not be in use for long periods.
Operating range of the remote
control unit
• Point the remote control unit at the remote
sensor when operating it.
• The remote control unit can be used from a
distance of up to about 7 meters, at a horizontal
angle of up to 30° with respect to the sensor.
30°
30°
Approx. 7 meters

NOTE:

• It may be difficult to operate the remote
control unit if the remote sensor is exposed
to direct sunlight or strong artificial light.

Part names and functions

Front panel

❶
POWER indicator
❷
POWER switch ( ON/STANDBY
❸
Remote control sensor
❹
BASS control knob
❺
TREBLE control knob
❻
BALANCE control knob
❼
VOLUME control knob
❽
MIC LEVEL control knob
❾
MIC INPUT jack
❿
INPUT SELECTOR knob
Use this to select the source that you wish to
listen to.
Input indicator
The selected input is shown with an orange
indicator.
MIC AGC(Auto Gain Control) button/
indicator
Adjusts the level to prevent clipping the sound
when mic input level is extremely high.
NOTE:
• This function works when the MIC MIX indicator
lights up.
2
ENGLISH
MIC MIX button/indicator
Mixes mic input with source input and outputs
OFF )
them.
AUTO MUSIC MUTE button/indicator
Use this to output source input as its level is
attenuated with the MUSIC MUTE LEVEL knob
on the rear panel when mixing mic input with
source input.
NOTE:
• This function works when the MIC MIX indicator
lights up.
LOUDNESS button/indicator
Amplifies the bass and treble sound that is hard
to hear at low volume level and achieves a more
natural sound.
SPEAKERS A/B buttons/indicators
Switches the speakers connected to speaker
output terminals.
ENGLISH
Getting Started