Fault - Angelo Po 191BR1E Bedien- Und Installationshandbuch

– Remove the limescale deposits which may form
on some of the appliance's surfaces.
Important
If it is not properly cleaned, the iron bottom
of the cooking well may rust. The well must
TROUBLESHOOTING
The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
Faults
No water delivered
The heating elements do not
come on
be thoroughly washed and dried after use,
and a thin even coating of edible oil or fat
must be applied to the bottom.

FAULT

The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
Filler solenoid valve faulty
Filling switch malfunction
Well raised or not resting on fixed
part of appliance
Electrical connection not made
correctly
Safety thermostat tripped
Switch faulty
- 13 -
Remedies
Check the solenoid valve
connection
Important
Contact the after-sales
service
Important
Contact the after-sales
service
Check that the well is not raised
or not resting firmly on fixed part
of appliance
Check the connection of the
electrical wires
Carry out the appliance reset (see
page 10)
Replace the switch
6
IT
GB
DE
FR
ES
NL
English