1 BY ONE Ring Collar Music Wireless Headset Bedienungsanleitung Seite 6

Automatic connection after powering on
When the earphone and phone have been paired once, they will
automatically connect when the earphone is on and Bluetooth is
activated on the phone.
Connection standby
After successful pairing and connection, you will hear the voice
prompt "Connection successful". the earphone will be in turning
on mode or standby mode automatically and the blue LED will
flash twice every 5 seconds, when the earphone disconnect the
phone due to invalid distance, you will hear the voice prompt
"Connection lost".
Voice dial (Need phone support.)
Press Vol+ and Vol- simultaneously, you will hear beep, and wait
for phone prompt and then tell the phone to dial the name of a
stored contact.
Charging
When battery is low, you will hear the voice prompt "Battery low".
It takes 1.5 hours to fully charge the earphone. The red LED
turns on during charging. The red LED will turn off and the blue
LED will turn on after being fully charged.
Note: The lifetime of the battery will be significantly reduced if your
earphone is left uncharged for a long period. We recommend that
you recharge your earphone at least once a month.
All manuals and user guides at all-guides.com
9
Clear paired list
In standy mode, press Vol+,Vol- and Multifunction buttons
simultaneously for about 5 seconds, LED indicator flashes
blue&red 4 times quickly, then clear all paired list, the earphone
will enter pairing mode automatically after power on next time.
Hard reset
If the earphone can not be turned on even when fully charged or
does not respond during use,follow the instructions below to
reset it:
1.While pressing and holding the multifunction button,connect
the earphone to your PC's USB or a USB adapter with the
charging cable.
2.Keep pressing and holding the multifunction button until
earphone turns on.The earphone should be reset successfull.
10