Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
15. Ensure before using the scooter that all locking devices are
engaged.
16. Immediately replace worn and / or damaged parts.
17. The scooter is suitable for use, only for one person.
18. Your scooter is an entry level stunt scooter with which you can
perform easy jumps and tricks.
Instructions for use
All beginnings are difficult, you therefore first have to master the ba-
sics of scooter-riding, and then progress with time. Be extremely cau-
tious and not rush anything. Please search for a stunt scooter school
in your vicinity, where different riding and animation techniques can
be shown to you.
The scooter is ridden by regular pushing the foot against the ground.
To brake, simply step on the brake plate of the rear wheel. The
braking force can be dosed by a light or firm step. Before you ride at
higher speeds, you should practice riding at a slower speed and try to
safely come to a halt. You should basically never ride faster than you
can run!
Maintenance and storage
Check the product for any damage or signs of wear, before and after
use. For your own safety, you should not perform any structural
changes and should exclusively use original spare parts that you
can purchase from a specialist dealer. The product should no longer
be used, if any parts are damaged or sharp corners and edges have
emerged. You should not use any special detergents when cleaning.
You should instead clean your product with a towel or a damp cloth.
For storage, we recommend a safe and sheltered place, so that people
may not be injured and the product may not be damaged. The ball
bearing is maintenance free and does not need to be oiled.
Pictures are
design examples.
Roller- /bearing change
Replacement rollers and bearings should be replaced if they are worn
or else abraded. Both are available as an accessory from your dealer.
To change the rollers, loosen the axle screw with the provided Allen
wrench and remove the roller from the axle. You can also use the
Allen wrench to press the ball bearing out of the wheel, in order to
use it again (We however recommend that rollers and bearings are
replaced together). Insert the bearing with the spacer back into the
new roller and use the axle screw to mount both on the scooter. Ensure
that the axle is again securely screwed on before using the scooter.
Disposal instructions
In the event of wear and expiry of the service life, please dispose the
product at the available return and collection systems. Questions can
be answered on site by the disposal company.
Service
Should you notice any defect on your product, we apologise for this
and we shall strive to rectify this defect as quickly as possible.
In this case, please contact:
service@authentic-sports.de
+49 2331 / 6289883
Authentic sports & toys GmbH
Gewerbepark Lennetal | Gründelbusch 33
58099 Hagen | Germany
www.authentic-sports.de
Art.-Nr.: 536, 548
Status 10/20
Page 4/8
Werbung
