WD Plus mybeo 303244 Bedienungsanleitung Seite 18

If the scale indicates an error, it is advisable to reset the device. To do this,
remove the batteries (see chapter 5. Replacing the batteries) and wait for approx.
10 seconds. Then the batteries can be inserted again.
7. Cleaning and care
Follow the safety instructions strictly while cleaning. Once the scale is switched
off, you can clean the surface using a damp, soft cloth.
Do not use any cleaning agents, solvents or scouring agents for cleaning. Use only
a soft cloth to clean the device.
8. Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not certified
for use in the open air; only use it in dry conditions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the de-
vice to sudden changes in temperature or heavy vibration as this might damage
electronic components. Examine the device for damage before using it. The unit
should not be used if it has received an impact or has been damaged in any other
way. Please observe national regulations and restrictions. Do not use the device
for purposes other than those described in the instructions. This product is not a
toy. Keep it out of the reach of children or mentally impaired persons. Any repair or
alteration to the device not carried out by the original supplier, will invalidate the
warranty or guarantee. The product may only be used by persons who have read
and understood these instructions. The device specifications may change without
any separate prior notice to this effect.
18
English