AIRFIX English Electric Lightning F1 Montageanleitung

1:48
A09179 SCALE MODEL CONSTRUCTION KIT | Wingspan: 225mm Fuselage Length: 350mm | Three Decal Schemes Included | Two Build Options
Designed at the height of the Cold War during the 1950s, the English Electric Lightning
GB
was the only all British Mach 2 fighter to enter service with the RAF, where its performance
placed it well ahead of contemporary rivals. The Lightning's engines were positioned in a
unique staggered stacked installation and their huge power gave the Lightning an exceptional rate of
climb, service ceiling and top speed. The F1 version of the Lightning entered service in 1959, with the
improved F1A following in 1961. Various improved versions of the Lightning were introduced through
the 1960s, all of them attempting to either improve the endurance of the aircraft, an area in which
the Lightning struggled, or the lack of armament options for the type. While successive variants did
improve these areas, the Lightning was still hampered by them up until its eventual replacement in
the late 1980s.
FOR BEST RESULTS:
Surfaces to be painted should be clean – before parts are removed from the sprue, wash in warm, soapy water, rinse
and dry thoroughly. Stir paints thoroughly before use.
PLEASE NOTE:
Some parts in the kit may not be required to build the model specified.
Hornby Hobbies Limited, The Gateway, 3rd Floor, Innovation Way, Discovery Park, Sandwich CT13 9FF, UK
Tel:+44(0)1843 233525 www.airfix.com
English Electric Lightning F1/F1A/F3
Specification:
Crew: 1
Speed: 1,500 mph (2414 km/h)
Wingspan: 34ft 10in (10.84 m)
Length: 55ft 3in (16.84 m)
Range: 799 miles (1287 km)
Armament: 2 x 30mm cannon plus 2 x Firestreak AAM