Motor Protection; Installing The Saw Blade; Cooling System; Connecting To Power Supply - B+BTec DIAMOND3 350RS Serie Bedienungsanleitung

GB
CAUTION! The saw head is
tightened by a spring and may
accidentally jump up when the
handle is loosened.
• For 45° Jolly sawing the upper frame
with the saw head can be tilted at a
45° angle . By loosening the 2 handles
at the front and back of the machine,
the upper frame can be tilted until the
end of the factory predefined 45°
angle .

Cooling system

NOTE! Operating the water
pump without a sufficient supply
of water may result in pump
damage.
• Place the plug in the drain of the water
container .
• Fill up the container with water until the
water pump is completely submerged .

Connecting to power supply

First, check whether:
• the line voltage corresponds with the
DIAMOND3
350 RS SERIES
®
data on the machine's specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm² .

Motor protection

The motor is equipped with a thermal
safety switch for protection against
an overload . When the motor gets
overheated the switch falls back into its
initial position and can only be switched
on again after the motor is cooled down .
The switch is also protecting against
power failure . When the power returns,
the motor will not start on its own but must
be switched on by hand .

Installing the saw blade

WARNING! Make sure you dis-
connect the machine from the
power supply before fitting or
switching the saw blade or when
performing any maintenance on
the machine.
• Remove the three knobs of the blade
cover .
• Block the sawing spindle with the 6
mm . Allen wrench .
• Unscrew the 22 mm . hexagon nut
with the wrench and remove the saw
flange . (Attention: Left-handed screw
thread.)
• Clean the saw flanges .
18