Intenso Memorysafe Bedienungsanleitung Seite 16

d) The green LED flashes rapidly now. Please confirm your new
password by entering it again and confirm your entry by pressing the
hash (#) key.
e) If the confirmation of the new password is successful, the green LED
lights up for 3 seconds. Then the red LED lights up again and the hard
disk is locked. If you enter the new password incorrectly when
confirming, the hard disk will be locked and the red or green status
LED will no longer be illuminated. Disconnect and reconnect the hard
disk again and enter your old password in order to regain access.
4. Correction of password entry
To reset the password entry during the current entry, please press the
star (*) key. To confirm the correction, the green LED will light up briefly
for three times.
5. Multiple incorrect entries of the password
If the password is entered incorrectly 3 times, the hard disk will be locked.
The red status LED will no longer be illuminated. In this case, the hard
disk must be re-connected to the computer. If the password is inserted
wrongly 100 sequent times, for safety reasons all data saved on the hard
disk will be automatically definitively deleted.
6. Password reset
Warning: Through this process, all data stored on the hard disk will be
permanently erased!
To reset the password, you must press the star (*) key and digit 1
simultaneously for the time required (about 3 seconds) until the green
and red LEDs start flashing in sequence. The system will now be re-
initialised and all stored data will be deleted. When initialisation is
completed, the LED will turn red.
In this state, the hard disk must be re-initialised in the "Disk Management"
of your operating system and formatted. For this purpose, the hard disk
must first be unlocked using the default password (1234). Please refer to
the valid instructions of the operating system you use for information on
how to proceed.
Page 6 of 8 GB