Charging The Product - nedis SPBT4100BK Kurzanleitung

•
Do not use the product where splashing of water might occur e.g.
bathrooms, swimming pools or close to a washbowls.
•
This product is equipped with a non-removable internal battery. Do not
attempt to replace the battery yourself.
•
Provide enough ventilation during charging.
•
Do not expose the product to direct sunlight, naked flames or heat.
•
Do not open the product.
•
Do not use the product at locations where the use of wireless devices is
prohibited due to potential interference with other electronic devices, which
may cause safety hazards.
•
Listening on high volume for a long time will damage your hearing.

Charging the product

1. Plug the micro USB cable A
2. Plug the other end of A
3. The status indicator LED A
5
4 A
turns off when the product is fully charged.
Pair with Bluetooth
1. Press and hold the power button A
product.
5
2. A
blinks and the product emits a tone to indicate pairing mode is active.
3. Enable Bluetooth on the device you want to pair the speakers with.
4. Select "SPBT4100" from the list of available Bluetooth devices on your device.
True Wireless Stereo (TWS)
4
TWS only works with two speakers of the same type.
1. Disable Bluetooth on the device you want to pair the speakers with.
2. Switch on both speakers.
3. Double press A
4. After a few seconds A
pairing mode is active.
5
5. A
of the other speaker lights up.
6. Enable Bluetooth on the device you want to pair the speakers with.
7. Select "SPBT4100" from the list of available Bluetooth devices on your device.
8. Double press A
3
into the micro USB port A
3
into a USB adapter.
5
lights up red.
1
on one of the speakers.
5
blinks and the product emits a tone to indicate
1
of one of the speakers, to switch off the TWS function.
1
for 2 seconds to switch on the
6
4
.