Using The Microphone - Behringer C-1U Bedienungsanleitung

26 C-1U User Manual
Mac OS:
5) Adjust the recording level as required, using Audio Midi Setup in Mac OS.
◊ ◊
Your C‑1U is now ready for use.
Complete the following steps should you want to use your C-1U by default in other applications:
Windows:
• •
Select the C-1U in the pull-down menu of Sound recording by clicking on Sounds and
Audio Devices in the Control Panel and then clicking the tab Audio
Mac OS:
• •
Select C-1U as Default Input found under the tab Audio Devices in Audio Midi Setup
of Mac OS

4. Using the Microphone

To get the sound you want, try changing the mic position relative to the sound source or even
move the microphone around in the recording room of your studio. Adjusting the angle at
which walls face the sound source can also be helpful. Only when the desired basic sound has
been achieved, should you start to use equalizers and signal processors, if any at all (remember:
less is often more!).
Due to the extremely linear frequency response and the high sonic resolution of your C-1U, there
is no need for high-frequency "EQing" that can heavily influence the signal and unnecessarily
increase the noise level. The C-1U provides that much-desired transparency which often gets
lost during recording and mixing.