Herunterladen Inhalt Inhalt Diese Seite drucken

DJI AGRAS T20 Schnellstartanleitung Seite 8

Vorschau ausblenden Andere Handbücher für AGRAS T20:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 63
Checking the Battery Levels
Press the power button on the remote controller once to check the internal battery level. Press once, then press again and
hold for two seconds to power on or off.
Press the battery level button on the external Intelligent Battery once to check the battery level.
When using an external Intelligent Battery, it is still necessary to make sure that the internal battery has some
power. Otherwise, the remote controller cannot be powered on.
Adjusting the Antennas
Lift the antennas and adjust them. The strength of the remote controller signal is
affected by the position of the antennas. When the angle between the antennas and
the back of the remote controller is 80° or 180°, the connection between the remote
controller and aircraft can reach its optimal performance.
Try to keep the aircraft inside the optimal transmission zone. If the signal is weak, adjust the antennas or fly the aircraft closer.
Optimal Transmission Zone
Avoid using wireless devices that use the same frequency bands as the remote controller.
If the RTK dongle is used for field planning, the module should be disconnected from the remote controller after
planning is completed. Otherwise, it will affect the communication performance of the remote controller.
4. Getting Ready for Takeoff
A. Place the aircraft on open, flat ground with the aircraft rear facing toward you.
B. Make sure that the propellers are securely mounted, there are no foreign objects in or on the motors and propellers, the
propeller blades and arms are unfolded, and the arm sleeves are
firmly tightened.
C. Make sure that the spray tank and flight battery are firmly in
place.
D. Pour liquid into the spray tank, and tighten the cover. Make sure
that the four lines on the cover are aligned to the horizontal or
vertical direction.
E. Power on the remote controller, make sure that the DJI Agras
app is open, and then power on the aircraft.
When using for the first time, activate the aircraft using the DJI Agras app. Your DJI account and an internet connection
are required.
Internet
Low
High
Low
High
80°
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis