Troubleshooting; Technical Specification - Revolution 233801 Gebrauchsanweisung

10. Troubleshooting

If the appliance does not function properly, please check the below table for the solution.
If you are unable to solve the problem, please contact the supplier / service provider.
Problem
The appliance is too noisy. - Appliance is not supported properly.
- The appliance does not
cool sufficiently.
- Freezing time too long.
- The compressor starts
too often.
Exterior (7) surface is too
wet.
EN

11. Technical specification

Item no.
Operating voltage & frequency
Rated input power
Rated current
Refrigerant used and quantity
Energy efficiency class
Setting: Temperature range
Climate class
Protection class
Noise level
Foam blowing agent
Freezing capacity
Net volume
Net weight
Approx. dimension
Remark: Technical specification is subjected to change without prior notice.
20
Possible cause
- Before switching on, the appliance
has not stand still long enough (3
hours) to level off the refrigerant
- The lid does not close tight.
- The seal is not placed tight enough.
- Excessive ice formation on the inte-
rior walls of the appliance.
- The appliance is located near the
heat source (e.g. stove, heater, etc).
- Put too warm or too much food in-
side cabinet of the appliance.
- Humidity of the outside environment
is too high.
233801
105W
R600a / 52g
E
4,7 kg /24hr
93L
27 kg
(W) 574 x (D) 564 x (H) 845 mm
Possible solution
- Check if the appliance stands
stable (all four feet should be on
the floor firmly).
- Let stand still again before start
to oper the appliance.
- Contact the supplier
- Contact the supplier
- Time to perform defrost.
See = = > Cleaning and mainte-
nance
- Keep the appliance away from
the heat source.
- Cool down the warm food before
put inside the cabinet.
- Do not put too much food inside.
- Put inside a air-conditined room
to lower the humidity.
233818
220-240V~ 50Hz
0,8 A
R600a / 58g
-28°C to -14°C
T
Class I
< 60 dB (A)
Cyclopentane
7,2 kg / 24hr
(W) 754 x (D) 564 x (H) 845 mm
110W
F
140L
31 kg