Control Panel Of The Appliance; Installation Of The Appliance - Revolution 233801 Gebrauchsanweisung

6. Control panel of the appliance

D
A. Temperature Regulator
The temperature can be adjusted by rotating this
knob in the range of setting 1 to 7.
Setting 0: At "Stop" mode, not operate.
Setting 1: Warmest temperature ( - 14°C to -16°C)
Setting 7: Coldest temperature (- 26°C to - 28°C)
Note: The setting temperature will be affected
by the below factor:
• Ambient temperature and humidity of the ap-
pliance
• Quantity of the stored food item
• Frequency of opening the lid
We recommend to place the food at the middle
position.
B. ALARM indicator (Red)
ALARM indicator light up in RED indicates the
internal temperature is too warm. During the

7. Installation of the appliance

Attention: Any installation, maintenance and repair work should be performed by qualified and authorized
technician only.
• Check to make sure that the appliance is un-
damaged or complete delivery (basket and drain
stopper are included). In case of any damage or
incomplete delivery, DO NOT use the appliance
and contact the supplier immediately.
• Remove all packing material and protective film
(if applicable).
• Let the appliance stand still for at least 3 hours
after installation before putting the appliance into
operation, this is to allow the cooling agent to lev-
el off for optimum efficiency.
• Place the appliance on a dry, level, steady and
safe floor away from any heat source. Recom-
mend to place in an air-conditioned room.
C B A
alarm phase, don't place food inside the appli-
ance.
It may be caused due to the following:
• First start up of the appliance
• Too much amount of fresh food has been put
inside the appliance for freezing. Chose a
higher setting
C. RUN indicator (Blue)
RUN indicator light up in BLUE indicate the
compressor is operating.
D. POWER indicator (Green)
POWER indicator will light up in GREEN when
the appliance is plugged in and temperature set-
ting (1 to 7) is selected.
• Avoid expose to direct sunlight or direct source of
heat such as cooker, heater, stoves, etc.
• Make sure that a minimum of 20 cm distance is
kept around all sides of the appliance for ventila-
tion purposes.
• Place the appliance in such a way that the plug
is easily accessible and can be quickly removed
from its socket in case of necessity.
• Due to heavy weight of the appliance, it should be
installed and moved by at least 2 persons.
• The inclined angle of the cabinet should not be
over 45° during transportation.
EN
17