Explanation Of The Warning Signs On The Machine; Layout And Items Supplied; Proper Usage - EINHELL NEW GENERATION EM 1200 Bedienungsanleitung

Anl EM 1200_SPK1 16.01.2006
thermoplastic material with the same
strength or they must be coated with this
material.
Ensure that you do not push the mower
over routes that might hamper the free
movement of the extension cable.
Do not switch the mower on and off
frequently over a short period of time, and
in particular do not play with the ON/OFF
switch.
As a result of the voltage fluctuations this
mower causes as it gets up to speed, other
equipment connected to the same circuit
may suffer faults if the mains supply is not
in perfect condition. In this case suitable
action has to be taken (for example connect
the mower to a different circuit or run the
mower on a circuit with lower impedance).
Disconnect the plug from the power supply:
- whenever you leave the mower.
- if the mower starts to suffer unusual
vibrations (check immediately).
2. Explanation of the warning
signs on the machine
(see Fig. 22)
1= Read the operating manual before using for
the first time
2= Caution, rotating blade
3= Keep others away from the danger area
4= Disconnect the mains plug before working
on the cutter unit
5= Caution, the blade will continue to turn after
the motor has been switched off
6= Switch off the motor and disconnect the
mains plug before carrying out adjustment
or cleaning work or if the mains lead has
been snagged or damaged.
7= Caution, keep the mains lead away from
the cutting tools.
13:32 Uhr Seite 21

3. Layout and items supplied

(see Figs. 1+2)
1. ON/OFF switch
2. Cable grip
3. Carry handle
4. Grass bag
5. Ejector flap
6. Power cord
7. Top push bar
8. Lower push bar
9. Push bar bracket
10. Fastening screws for push bar
11. Cable clips
12. Fastening screws for push bar bracket
13. Key for changing the blade
14. Frame parts for grass bag

4. Proper usage

Power connection
The lawn mower can be connected to any
socket (with 230 V alternating current).
However, only use a socket with an earth
connection protected by a cable protection
switch for 16 A and an RCCB with max. 30
mA.
Additionally, a residual current device (RCD)
circuit-breaker with max. 30 mA must be used!
Mower mains lead
Only use a mower mains lead that is in perfect
condition. The mains lead must not exceed a
certain length (max. 50m), since otherwise the
power of the electric motor will fall. The mains
lead must have a cross-section of 3 x 1.5mm
Mains leads on lawn mowers are particularly
susceptible to insulation damage.
The causes of this include the following:
GB
2 .
21