Waldbeck 10030931 Anwenderhandbuch Seite 27

Pulsing machine�
The machine turns on and
off by itself
The machine is on but no
water comes out�
Air in inlet hose / pump
Inadequate supply of water
generated
Partially blocked jet
Water filter blocked
Folded pipe
Pump fuse and/or trigger
out of order
No water supply
Water filter blocked
Blocked jet
Allow machine to run with
open trigger until regular
working pressure resumes�
Increase water pressure,
check for blockages and / or
change the large pipe�
Clean the jet with a needle
and by spraying water rear-
wardly through the jet
Clean the filter
Unfold the pipe
Contact your nearest ser-
vice centre
Connect the inflow water.
Clean the filter
Clean the jet with a needle
and by spraying water rear-
wardly through the jet
27