Waldbeck 10030931 Anwenderhandbuch Seite 18

the requirements below regarding the length and dimensions of the cable�
• 1,0 mm ² max� 12,5 m
• 1,5mm²max�20 m
• If the power cable is damaged, it must be replaced by the manufacturer, their service
agent or a qualified professional in order to avoid any danger.
• WARNING: This machine is not designed to be used by persons (including children)
with reduced physical, sensory or mental capacities or whose lack experience or
knowledge�
• WARNING: It is advisable that you supervise children to ensure that they do not play
with the appliance�
• CAUTION – Risk of explosion – do not spray flammable liquids, do not direct the jet
towards flammable liquids.
• WARNING: Water that has circulated in the anti-backflow system is not considered
drinkable�
• WARNING: Do not use the appliance if the power cable or important parts of the
appliance are damaged, for example, the safety devices, high pressure hoses and
handgun�
• WARNING: If you have an extension cable, it must be waterproof�
• WARNING: When you switch on the machine, a recoil movement is produced due to
the force of the water jet. Use two hands to control the lance. Wear safety gloves
when using the appliance� Wear suitable protective clothing�
• In case of accidental contact with detergent, wash with water� If the liquid comes into
contact with the eyes, also seek medical assistance (the detergent can cause irrita-
tions or burns)�
• In the event that the appliance breaks down, do not attempt to repair it yourself but
contact a professional technician to avoid any danger�
Main power connection
The following must be observed when connecting the high pressure washer to the power
supply:
• Connecting the electrical connection should be done by a qualified electrician con-
forming to 60364-1 CEI�
• It is recommended that the electrical supply to this machine should comprise a re-
sidual current device which interrupts the current if the leakage current exceeds 30
mA for 30ms�
Connecting to the water network
• According to current guidelines, the unit must never be operated without a system
separator on the potable water system� Use a EN 12729 type BA system separator�
Water that passes through a system separator is classified as non-potable.
18