Waldbeck 10030931 Anwenderhandbuch Seite 22

5. Start/stop of the machine
The trigger gun (1) and lance is affected by a thrust during operation - therefore always
hold it firmly with both hands.
Notes:
Check that the machine is in upright position.
Do not place the machine in high grass!
Starting the machine
Release the trigger lock�
Activate the trigger of the trigger gun (1) and let the water run until all air has escaped
from the water hose�
Press the Start/stop switch (7)�
Activate the trigger of the trigger gun (1)�
Always adjust the distance and thus the pressure of the nozzle to the surface, which is to
be cleaned�
Do not cover the machine during operation or use it in a room without adequate ventila-
tion�
Note:
If the machine is left or not used for 5 minutes, it must be switched off on the
start/stop switch (7) "O".
Stop
Press the start/stop switch (7) "O"�
Disconnect the electrical plug (12) from the socket�
Shut off the water supply and activate the trigger of the trigger gun (1) to relieve the
machine of pressure�
Lock the trigger gun (1)�
6. Multi Nozzle
The pressure can for the multi nozzle be adjusted by tuning it. WARNING: Do not do this
under operation to avoid that the hand hits the jet.
22