Gamma Piu Absolute ALPHA Gebrauchsanleitung Und Garantie Seite 17

Maintenance, replacement and adjustment of the head
The head components can be sharp. Take particular care during the
whole procedure.
• Unscrew the screws of the head and remove the cutting comb and the blade
(Fig. 4)
• Clean all the parts from any remaining hair.
• Reassemble by inserting the blade into the plastic feeder.
• Apply the comb and put the two screws back in.
• Before tightening the screws, check that the blade is aligned laterally to the comb
(Fig. 5–b/c) and align the comb so that between the front edge of the comb and
the front edge of the blade there is an approximate distance of 0.5 mm (Fig. 5-a).
• Tighten the screws.
• Recheck alignment of the cutting comb again.
• Repeat this procedure if alignment is poor or unsafe.
• Before using the appliance, check that it is working properly.
Incorrect alignment of the blade and the cutting comb can cause
injury. Ensure proper adjustment.
Lubrication
It is recommended to lubricate the blade unit daily or after every use.
To ensure that the cutting blade remains sharp, the cutting head must be lubricated.
It is recommended to regularly apply two to three drops of lubricant M (fig. 1) directly
on the blade (fig. 5).
If after a long period of use, and despite constant cleaning and oiling,
the cutting performance decreases, the head must be replaced.
Failure to lubricate the appliance is considered as "FAILURE TO COMPLY WITH
THE INSTRUCTIONS FOR USE", therefore, the warranty will be automatically
rendered null and void.
DISPOSAL
The product packaging is made of recyclable materials. Separate the parts
according to their type and dispose of them in accordance with applicable
laws on the environmental protection.
INFORMATION TO USERS in accordance with Legislative Decree No.49
of 14 March 2014 "Implementation of Directive 2012/19/EU on waste
electrical and electronic equipment (WEEE)"
The crossed bin symbol on the appliance indicates that at the end of its life-
span, the product must be collected separately from other waste. The user
must deliver the appliance, with the essential components, at the end of its
life-span, to the appropriate separate collection centres for electronic and
electrotechnical waste, or return it to the dealer when a new applicable of
equivalent type is purchased, at the rate of one to one, or 1 to zero for
appliances with longer side of less than 25 mm. Adequate separate collection
for subsequent start of the appliance discharged to recycling, treatment and
17