Pack Contents; Installation - Polar U Serie Bedienungsanleitung

UK
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your POLAR product.

Pack Contents

The following is included:
• POLAR Refrigerator or Freezer
• Shelf guide (2 per door) except GL182 (14 per
door)
• Shelf (1 per door) except GL182, GL183 and
GL184 (No shelves included)
• Instruction manual
• Spacer (x2)
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.

Installation

Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
To avoid being pushed tight against
the wall accidentally and ensure good
ventilation, 2 spaces are supplied for
mounting on the rear.
3. Set the brakes on the castors to keep the
appliance in position OR
Level the appliance by adjusting the screw
feet.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water.
4
G377-G379_G596-G600_GD873-GD874_DL914-DL917_GL182-GL184_ML_A5_v6_20201126.indb 4 G377-G379_G596-G600_GD873-GD874_DL914-DL917_GL182-GL184_ML_A5_v6_20201126.indb 4
Fitting the Shelves
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
Attach Refrigerated Counter Top
G611 (for GL182 Only) (This is
optional)
1. Remove the appliance from the packaging.
2. Tip the appliance back and loosely attach the
three brackets to the underside of the counter
top, using suitable screws. Do not fully tighten
at this stage.
Note: Ensure the two 'L' shape
brackets are fitted to the
outside edges.
3. Lower the Counter Top unit onto the marble
sides. Ensure the side brackets are postponed
on the inside of the marble rim.
4. Push the side brackets flush with the marble
and tighten the bracket screws.
Fit Glass Panels G611 (for GL182
Only)
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the
collar for the grub screw faces
inwards.
2020/11/26 14:06 2020/11/26 14:06