vlahova RB658 Gebrauchsanweisung Seite 19

(Snooze Interval Time Setting Display）
•
Setting snooze item twinkling at 1HZ frequency
•
Press "UP" key, value go ahead 1 step, press and hold "UP" key for 2 seconds, go ahead at an 8
step/second speed.
•
Press "DOWN" key, value go back 1 step, press and hold "UP" key for 2 seconds, go back at an 8
step/second speed.
•
After setting, press "MODE" to exit.
•
No any key press for 10 seconds exit setting status, value keep on.
5. Temperature and Humidity Function
•
Out of the indoor and outdoor temperature display, the low end displays "LL", the high end
displays "HH".
•
Under normal mode, press "CHANEL" key to switch outdoor temperature and humidity display,
switch in sequence: CH1 temperature and humidity→ CH2 temperature and humidity→CH3
temperature and humidity→ CH1 temperature and humidity (cycle display, symbol
on the LCD display)
•
Under normal mode, press and hold "CHANEL" key for some seconds, clear the outdoor
temperature and humidity, then re-register for 3 minutes.
•
Under cycle display mode, no register no display, directly jump to registered channel display.
•
Under normal mode, press "UP" key to switch temperature unit (℃ or ℉)
6. Temperature Alert Setting
•
Under time mode, press "ALERTS" key to check temperature alert for both highest and lowest
indoor and outdoor temperature.
•
Under temperature alert mode, press "UP" key or "DOWN" key to turn alarm on/off. After
Alarm On, corresponding alarm symbol
•
Under time mode, press and hold "ALERTS" key for some seconds to check temperature alert
both highest and lowest outdoor and indoor temperature in sequence: highest outdoor
temperature→ lowest outdoor temperature→ highest indoor temperature→ lowest indoor
temperature→ exit
•
Indoor temperature upper limit: 50C, low limit: 0C.
•
Outdoor temperature upper limit: 70C, low limit: -40C.
•
Setting item twinkling at 1HZ frequency.
•
Press "UP", value go ahead one step; press and hold for 2 seconds, go ahead at an 8 step/second
speed.
•
Press "DOWN" key, the value go back one step; press and hold for 2 seconds, go back at an 8
step/second speed.
•
After setting, press "ALERTS" to confirm.
•
No any key press for 10 seconds exit automatically setting status.
7. RCC Receiving Function:
• After power on or reset, after testing temperature and humidity start receiving RF for 3 minutes
automatically.
• Press and hold "DOWN" key for 2 seconds to enter into RCC receiving.
• Daily auto receiving
will display.
appears