Samsung RS54 Serie Benutzerhandbuch Seite 7

Drawer replacement
CAUTION
Check that the drawer is inserted properly into the rail during assembly.
To remove the drawer
To reattach the drawers
Reattaching the drawers follows the reverse order of their respective removal steps.
Hinge replacement
To replace the hinges, you must remove the doors first.
CAUTION
When removing the doors, take extreme caution because the doors are heavy.
•
Before replacing the hinges, put a soft pad such as cardboard on the floor to prevent scratches on
•
the door when you place the doors down.
As the hinges must be handled carefully and replaced by two or more persons, we recommend you
•
to call for professional technical service.
If you remove the hinge without holding the door, the door may fall and cause injury.
•
Ensure that the shaft is firmly tightened on the hinge.
•
Check that the hinge is firmly attached to the cabinet.
•
Make sure the wire connectors are connected properly.
•
Be careful not to damage the wires when fastening the top cover.
•
WARNING
Tilting/laying the refrigerator requires a minimum of 2 people.
•
Disconnect the power cord before reversing the doors.
•
Tools required (not provided)
Philips screwdriver
10 mm socket wrench
1. Pull out the drawer as far as it goes.
2. Tilt the drawer up and pull it out until it
is removed.
Flat-head screwdriver
8 mm socket wrench
English - 6
11 mm spanner
10 mm spanner