Troubleshooting; Specification - Rebel URZ3471 Bedienungsanleitung

Note: one button on remote transmitter can program one or more
sockets.
REMOTE CONTROL BATTERY INSTALLATION
Regularly change the battery in the remote control for optimum operation.
However, if you find the socket not responding or the indicator light
becomes dim, change the battery of the remote control:
1. Slide the battery compartment cover to open it.
2. Install one A23 (12 V) battery. Note the correct polarity.
3. Close the battery compartment.

TROUBLESHOOTING

In case, one of the sockets do not respond to the remote control, follow
the steps below:
1. If the socket does not respond after All ON/All OFF button has been
pressed once, press the button for the second time (it may not
respond due to installation on different range places).
2. Replace battery in remote control.
3. Make sure the socket and the external device are correctly
connected.
4. Reset and reprogram the socket as instructed in "Resetting Socket
(Cancel Programming)" and "Programming" paragraphs in this
instruction manual.
5. Make sure the maximum load current of 10 A (approximately 2300
W) is not being exceed. If so, unplug the device from the socket
immediately
EN
18

SPECIFICATION

• Rated voltage: 220-240 V AC | 50-60 Hz
• Max load power: 2300 W
• Max load current: 10 A
• Remote control frequency: 433,92 MHz
• Remote control range: up to 30 m
• Remote control battery: 1x A23, 12 V DC
LEARN MORE
For more information on this device visit: www.rebelelectro.com.
Read owner's manual carefully before using your device.
Visit www.rebelelectro.com website for more products and accessories.
Lechpol Electronics Sp. z o.o. Sp.k. hereby declares that Power socket
with remote control URZ3471 is consistent with directive 2014/53/UE.
Full text of the EU Declaration of Conformity is available at following
Internet address: www.lechpol.eu.
19
EN