Troubleshooting - Rebel URZ3469 Sicherheitsanleitungen

DELETING SOCKET PAIRING
1. If another device is connected to the socket, disconnect it.
2. Disconnect the socket from power outlet.
3. While holding programming button, plug the socket to the power outlet.
4. After about 5 seconds power indicator will start flashing. Pairing has
been successfully deleted (programming button can be released).
PAIRING THE SOCKET WITH THE REMOTE
1. To pair the socket with the remote, exsisting pairing must be deleted.
To do it, follow steps in paragraph above.
2. Press and hold programming button on the socket until power
indicator starts flashing. Release the pairing button.
3. While power indicator is flashing, press the ON or OFF button next
to the chosen number on the remote.
4. After successful pairing, the power indicator will stop flashing.
Note: up to three sockets can be assigned to one number on the remote.

TROUBLESHOOTING

If the socket is not responding to the remote, follow steps below:
1. Follow steps in paragraphs "Deleting socket pairing" and "Pairing the
socket with the remote".
2. Replace the battery in the remote.
3. Make sure that the sockets are plugged properly to the power outlet.
4. Make sure that the sockets are placed in a well-ventilated position to
prevent overheating.
EN
16