Product Description; Operation - Rebel URZ3471 Bedienungsanleitung

PRODUCT DESCRIPTION

1. Programming/ON/OFF button
2. Socket LED indicator
3. Remote LED indicator
4. ON/OFF buttons
5. All sockets ON/OFF butto

OPERATION

1. Plug this socket into a wall power mains socket.
2. Connect an external device into this socket.
3. Press the ON button on the remote control or the ON button on the
socket to turn on the corresponding socket accordingly.
4. Press the OFF button on the remote control or the OFF button on the
socket to turn off the corresponding socket.
EN
16
5. Press All ON / All OFF buttons to turn on/off all the matched sockets
to the remote.
Note: The socket remains in the OFF mode after a power cut, even when
power comes on again.
DELETING SOCKET PAIRING
To reset a socket from all remote control parings, follow the steps below:
1. Unplug the external device connected to this socket.
2. Remove this socket from the power mains socket.
3. Press and hold the program button on this socket. Connect this
socket back into power mains socket while continuing to hold
program button for approximately 5 seconds until the indicator
begins to flash. Release the button.
4. Resetting has been successful when the indicator on this socket
flashes several times and stops blinking.
PAIRING THE SOCKET WITH THE REMOTE
The sockets and remote control have been pre-set and can be used
immediately.
To re-program the remote control and a socket receiver, follow the
instructions below:
1. First, reset the socket as indicated in the "Resetting Socket (Cancel
Programming)" section above.
2. Press and hold the programming button on the socket until indicator
starts to blink.
3. Release the programming button on the socket. Press the ON or OFF
button of any desired number on the remote control you wish to
program the socket to.
4. Programming is successful when indicator light stops blinking.
17
EN