For Operation; Technical Specifications - walser mantona Scout Bedienungsanleitung

2. For operation:

• Pull the levers for leg angle adjustment
• Adjust the legs, until the most suitable working angle is reached
• Open the clips on the tripod legs
• Extend the legs to their full length
• Tighten the quick-action locks
3. Near ground level work
• Loosen the lock on the centre column
• Remove the rubber cap from the underside of the centre column
• Slide the centre column out of its holder
• Turn the column around by 180 degree
• Fasten the centre column at a suitable working height
• Fasten the protective cap on the column
4. Removing the quick-release plate
• Press in the locking pin
• Loosen the locking lever for the quick-release plate
5. Locking the ball head
• Use of the locking lever on the ball head
(if the position does not permit locking)
• Pull the locking lever
• Turn it to a suitable position
• Let the lever click into place
• Tighten the ball head
Attention!
Back out the fastening screw only so far, that the ball
head is free to move, to prevent the inside of the head
from being damaged.
8
6. Technical specifications
Scout
Max. height 144 cm
Min. height 35 cm
Tripod connection 3/8 Zoll
Length of centre
35 cm
column
Transport size 58 cm
Weight approx. 1,6 kg
Max. load bearing
5 kg
capacity
Material Aluminium
Scope of delivery:
Camera tripod Scout, ball head,
allen key
Scout MAX
Max. height 160 cm
Min. height 60 cm
Tripod connection 3/8 Zoll
Length of centre
36 cm
column
Transport size 63 cm
Weight approx. 1,9 kg
Max. load bearing
6 kg
capacity
Material Aluminium
Scope of delivery:
Camera tripod Scout MAX, ball head,
allen key
9