Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; Ncorrect Use; P Rior To Taking The Machine Into - SUHNER ABRASIVE LWA 70-KF Originalbetriebsanleitung

1. N
1.1 General notes on safety
This operation manual is applicable for the machine LWA
70-KF.
The machine may only be handled by personnel
who are qualified.
1.2 Use of the machine for purposes for
which it is intended
The tool is designed for grinding, metal, stone, and plastic
with grinding tools.
1.3 Incorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 EC declaration of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. C
2.1 Prior to taking the machine into service
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.1.1 Mount the supply hose
Screw connection nipple into the valve body, invert suply
hose through connection nipple and fix it with hose clamp
(available as an accessory).
16
S
oTES oN aFETy
ommISSIoNINg
2.2 Taking the machine into service
Before connecting the tool to the com-
pressed air supply set the sleeve to the
«OFF» position! The tool may be switched
on only when the attachment have been installed correct-
ly.
2.2.1 Turn on/Turn off
Turning on the machine by moving the sleeve in the ar-
row direction. Off by moving the sleeve in the opposite
direction.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.2.2 Setting the air direction
The side air direction can be adjusted by turning the
sleeve.

2.3 Rating data

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Max. wheel diameter
Sound pressure level EN ISO 15744 78dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
max. 6.3bar
75W
0.22m /min
3
0.24m /min
3
about 1 drops/min
70000min
-1
19-22mm
1.6m/s , K=1.24m/s
2 2
2/4/4
0.180kg