Custom Settings - Marshalltown Bullet 930-Rct-Pc Bedienungsanleitung

Sharpening the Blade
The blade can be sharpened to restore a one-sided, 21° – 22° knife edge. It is important to note that the blade
must be sharpened only on the beveled side, leaving the flat side flat. We recommend that power grinding only
be done professionally, as the blade must be fluid cooled during this process.
Backstroke Stop – To cut approved products over 3/4"
(19mm) thick, loosen Phillips head screw on the Backstroke
Stop; turn the Backstroke Stop 180º and tighten screw. For
more convenience when cutting thinner products, restore
factory setting.
The Anvil – The anvil has two edges: a 1/32" (0.75mm) narrow
edge and a 3/16" (4.5mm) wide edge. Either edge can be used
according to the support needed to make a clean cut (some
soft-backed products require the wider anvil edge).
To Change Between Anvil Edges –Simply remove the anvil
screws and flip the anvil over. Ensure blade stop is in place.
Cutting Depth – You may need to adjust the height of the blade to cut all the
way through your product. You can do this by:
Adjusting The Stop Screw
1. Loosen the stop screw nut and turn stop screw until it is
loose. Release handle to open blade.
2. Push the handle down until the blade is resting on the
"blade stop"
3. Adjust the stop screw until it contacts the power assembly.
Fine Tune Your Fence – The fence on Soft Flooring Shears is
adjustable to 1/2 degree in either direction of square. To make
fine adjustments:
1. Loosen (but do not remove) the three Phillips screws
which secure the fence.
2. Rotate the fence to the desired angle.
3. Re-tighten the three Phillips screws.
WS2646
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

CUSTOM SETTINGS

9 of 18