Marshalltown Bullet 930-RCT-PC Bedienungsanleitung Seite 6

Step 4 – Attach the Casters (G) to the Long Rail (C) and Short Rail (F)
through the Power Assembly (B) using Machine Screws (A) threaded
with the Star Washers (P). As you face the blade, ensure the Long
Rail (C) is on the left and Short Rail (F) is on the right. The Casters (G)
wheels should be closest to the ground
Step 5 – Attach the Table Assembly (A) to the base. Use Machine
Screws (N) to attach Table Assembly (A) to the Power Assembly (B).
Use Self Tapping Screws (M) to attach Table Assembly (A) to the Long
Side Tail (D) and Short Side Tail (E)
Step 6 – Attach the Handle Assembly (H) to the Power Assembly (B)
using the bolt in the Handle Assembly and the Allen Wrench (L)
Step 7 – Slide the Handle Extension (I) into the Handle Assembly
(H) by pressing the bolt on the Handle Extension. Make sure the bolt
on the Handle Extension (I) lines up with the holes on the Handle
Assembly (H)
Step 8 – Attach the Angle Guide (Q) to the Table Assembly (A) by using
the attached thumbscrew
Step 9 - Only applicable to 940-RCT40 – Attach the Middle Tail (S) to
the Table Assembly (A) by using 2 Self Tapping Screws (M).
6 of 18
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
ASSEMBLY
WS2646