Maintenance - Marshalltown Bullet 930-Rct-Pc Bedienungsanleitung

MAINTENANCE

Honing the Blade
Push the handle down until the blade 1/8" (3mm) above
the tabletop. Place the provided Hone Stone against
the flat side of the blade. Slide the honing stone from
one end of the blade to the other 3-4 times. This will
For more information on honing
remove any burrs from your blade
your blade, scan the QR code
or visit
www.marshalltown.com/
honing-your-blade
When you first get your shear, you should hone after your 5th cut, then hone your blade every
10th cut for the first 100 cuts until your blade is broken in. From there, you only need to hone once per job.
Use caution when honing the blade. The blade is sharp and can easily cause injury. Cut resistant gloves are
recommended when honing the blade
WARNING
Changing The Blade
! !
USE EXTREME CAUTION! Blade is very sharp.
Required tools: #3 Phillips screwdriver
1. Turn The Shear Upside Down
Tip: put the shear on the edge of a sturdy table.
2. Loosen The Blade
Using a #3 Phillips screwdriver, remove the blade screws.
3. Remove Blade
Hold blade by each end and carefully lift out of pocket.
4. Install Blade
Hold blade by each end and carefully place into the blade pocket in the head, with
the flat side of the blade facing the table. Be sure that it is firmly seated, and the
pocket is clear of debris.
5. Tighten The Blade
Using a #3 Phillips screwdriver, replace and tighten the screws, starting with the
center screw.
Note: This image is for a 13" Magnum Edge.
Your shear may look different.
Lubricating
Regularly lubricate your shear (every few hundred cuts or once
per job). Use a light oil (e.g. 10W motor oil or WD-40) to lubricate
the sliding contact faces where indicated. Wipe off any excess. If
you are concerned about oil stains on your flooring, use a spray-
on PTFE lubricant like Slick-Shot™ shear lubricant in place of oil.
Adjusting The Blade
Your Magnum Flooring Shear is equipped with adjustment "jack"
screws for fine tuning the angle of your blade or compensating for
small blades (Blades shrink every time they are re-sharpened). To
tilt your blade, turn the machine upside down as when removing the
blade. Loosen (but do not remove) the screws. Adjust the jack screws
to desired position with 5/32" or 4mm Allen wrench.
The Blade Stop
The blade stop may become worn. Remove anvil, turn blade stop over for more use. Replacements can be
purchased at your dealer.
8 of 18
WS2646
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com