Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USER INSTRUCTIONS / FUNCTIONS
5. HEIGHT ADJUSTMENT
Procedure
Slightly loosen the
Pull the handle until
spring-loaded
the safety bolt is no
clamping knob
longer engaged
of the 18811
stacker
6. INCLINATION: 0° - 5° - 10° - 15° - 20°
6.1 Disassemble the screw connection
6.2 Align U-strut as desired (5 alternatives)
6.3 Disconnect U-strut and tube using the
carriage bolt and secure
with clamping nut
8. DEPTH OF SUPPORT: 4 positions
8.a Completely loosen both screw connections
8.a
of the support tube
8.b Position the support differently (4 possibilities)
8.c NOTE: Distance always two holes
8.d Reassemble both screw connections
Support tube
9. DIMENSIONS
Connection to 3rd level, K&M 18822
Height adjustment:
- 10 steps
- distance: 12.5 mm each
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
18823-021-55 Rev.1a 03-80-522-00 9/20
Extract or
retract
support tube
from below
Engage safety bolt in
the desired hole and
retighten spring-loaded
clamping knob
7. PLACING THE RUBBER PADS
7.1 Rubber pads a must be placed on each of the two support tubes.
7.1
Pull off the adhesive foil and press on the desired position.
7.2 Position and spacing depends on the size of the keyboard and should be cho-
7.1
sen so that the equipment rests as far as possible secure and wobble-free.
FAULT FINDING (F) and REPAIR (R)
F: Stacker wobbles
R: Tighten the spring-loaded clamping knob 5.4.
R: Tighten screw connection 3.2.
F: Keyboard wobbles R: Adjust the support to the same height 5, inclination 6 and depth 8
R: Correct the position of the rubber pads 7 (01-09-019-55)
CHECK, MAINTAIN, CLEAN
- Visually inspect the product before and after use;
damaged parts are not be used or only after repair
- Maintenance and care should only be carried out when not under load
- Pay attention to possible hazards during maintenance work (bumping, jamming, etc.)
- Use a slightly damp cloth for cleaning; do not use abrasive cleaning agents
TECHNICAL DATA
Material
Dimensions
Load
Packaging
The height of the stacker can
be adjusted in 10 steps,
Tubes, struts: steel, powder-coated black
Plastic parts: PE, TPE, PUR black
Attachment: width: 40 mm, depth: 400 mm
max. 25 kg
Cardboard, inside: 505 x 92 x 66 mm
each 12.5 mm
Werbung
