Sanit INEO BRIGHT Montage- Und Bedienungsanleitung Seite 21

ENGLISH
EN
Parameter Factory setting
Range test
OK - Start
Range setting
OK - Start
System info OK
User counter
OK - Reset
Factory setting
OK set
Intermittent flush
Reduced flush
OK
Reduced flush
D
Reduced flush
T
Language
> German >
Setting ranges
off-1-3-6-12-24-48-
24 hours
72-96-108 hours
0 from -10 to +10
German German/English
Function
Every 3 seconds bright red color for 0.5 seconds
and the different areas are signaled by the following
colors: Area 3 - BLUE
Area 2 – WHITE
Area 1 - GREEN
Function ends after 1 minute or upon actuation of
flush.
Used to automatically set the sensing range of the
presence. When this function is started no person
and objection may be in the required sensing range,
but max 1.5 m. Doors projecting into the sensing
range when opened, have to closed immediately after
activation (e.g. WC cabin). The actuator plate is ready
for use after 30 seconds and the room can be entered
again.
Query sensor runtime: days ..........
User counter: ..........
Total number: ..........
Flush (aggregate) User counter: ..........
Total number: ..........
Full flush, User counter: ..........
Total number: ..........
Reduced flush, User counter: ..........
Total number: ..........
Intermittent flush, User counter: ..........
Total number: ..........
Use, User counter: ..........
Total number: ..........
Code number: .......... / Software ID: ..........
Resets the user counter
All parameters are reset to factory setting.
An automatic full flush is initiated after last use
within the time set.
Check of reduced flush
Correction of motor for reduced flush
Actuation speed of motor to set reduced flush volume
Menu language
21