Installation - EuroLite STV-40 Bedienungsanleitung

INSTALLATION

Please consider the
installation! The installation must only be carried out by an authorized dealer!
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Before lifting or lowering the telescopic tubes, you must always block a safety area around the stand. This
safety area must have a diameter of 1.5 times the maximum height.
Procedure:
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the loads. If you lack these qualifications, do not attempt the installation yourself, but
instead use a professional structural rigger. Improper installation can result in bodily injury and/or damage to
property.
Loosen the fixation screw of the legs. Pull the legs out until the cross struts stand at a 90° angle to the legs.
Tighten the fixation screw of the legs.
Installation of the crossbeam
Attach an appropriate crossbeam to the top end of the stand and fasten the fixation screw.
Installation of the devices
Caution: The loads have to be installed in a balanced way.
Caution: The carrying capacity of the stand must never be exceeded!
Install the devices on the crossbeam and do always install an appropriate safety bond.
You must only use safety bonds and quick links complying with DIN 56927, shackles complying with DIN EN
1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the carbines must be sufficiently
dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV C1,
BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
In order to adjust the stand height, loosen the fixation screw of the individual telescopic tube and pull it out.
Make sure that the maximum lifting height of the tube is never exceeded. As soon as you have reached the
desired height, tighten the fixation screw.
DANGER TO LIFE!
DIN 15560-27 and the respective national norms during the
13/14 00118373,Version 2.0