Replacing Door Seal; Removing Door Seal - Siemens iQ500 Serie Reparaturhinweise

Repair

4.4 Replacing door seal

Caution
Sharp housing edges!
Cut injuries
▶ Wear protective gloves.
Caution
Risk of falling parts due to released screws!
Injury because of falling parts.
▶ Secure component from falling down.
Notice
Risk of falling parts due to released screws!
Damage to other parts of the appliance or at customers home e.g. bot-
tom.
▶ Secure component from falling down.
Prerequisite:
Appliance is disconnected from power supply.
Appliance is disconnected from water supply.
Detergent drawer has been removed.
Door has been removed.
Base cover removed.→ Page 62

4.4.1 Removing door seal

1.
Caution
Risk of falling parts due to released screws!
Injury because of falling parts.
▶ Secure component from falling down.
Notice
Risk of falling parts due to released screws!
Damage to other parts of the appliance or at customers home e.g.
bottom.
▶ Secure component from falling down.
2021-02-19_8001214500
Remove screws from in following order (1-2-3-4).
2. Release screws at back of appliance.
3. Remove worktop.
4. Release catch elements of fascia panel at top and on right side.
5. Remove fascia panel.
6. Remove drum light holder at top.
7. Release screws of dispenser housing.
8.
Remove tension ring from gasket with a plastic tool.
9. Release door seal from front panel.
10. Release cable connector from door lock.
11. Remove front panel.
Copyright by BSH Hausgeräte GmbH
Notice
Risk of damaged surface!
Surface of appliance can be scratched by using wrong tools.
▶ Only use plastic tools to replace the tension ring.
Page 65 of 265