Canon Pixma TS5000 series Inbetriebnahme Seite 4

Installing the Ink Tank
You can watch the procedure on a movie by scanning
the QR codes.
1
Open the scanning unit / cover.
Do not touch the print head holder (A) until it
stops.
2
a R emove the orange tape.
b R emove the protective wrap.
b
Remove the orange tape completely.
3
Hook the orange cap with your finger to remove it
GENTLY.
(A) Do not push the both sides of the ink tank with
the Y-shape air hole blocked.
(B) Do not touch.
(A)
4
Insert the ink tank into the print head holder and
push it down firmly until it snaps into place.
After the lamp lights up, install the next ink tank.
2
Android
(A)
a
(B)
5
Check that all lamps are lit.
6
Close the scanning unit / cover.
iOS
If an error message appears, make sure the ink
tanks are installed correctly.
Loading Paper / Aligning the Print
Head
You can watch the procedure on a movie by scanning
the QR codes.
To obtain better print result, print a pattern for print head
alignment and scan it.
1
Open the rear tray cover and pull out the paper
support.
Android iOS